Exterior-Tite has been designed for high quality outdoor ironmongery. Rust proof screws that will last the lifetime of the application. Say goodbye to ugly rust stains ruining your outdoor ironmongery.
Exterior-Tite grips the wood fast so won't unscrew over time
Features the unique Tri-Lock threadform - the benefits of a twin thread and a single thread screw on the same screw. Two screws in one
Available in black to match most outdoor ironmongery whilst providing superior corrosion protection
Suitable for all timbers including pressure treated timbers
Accredited by the Timber Decking & Cladding Association
Stormboard Agri sheet is manufactured from 100% waste plastic which typically ends up being land-filled or incinerated. Stormboard Agri has been manufactured as an alternative to imported plywood, or to virgin plastic panels, yet in turn are fully recyclable at end-of-life.
Rigid sheet available in 19mm
It can be cut/screwed in the same way as traditional timber
Significantly longer lasting compared to timber and plywood
PVA D4 is a solvent free industrial grade D4 wood adhesive based on the latest hybrid resin technology. PVA D4 provides the user with a waterproof D4 grade adhesive with none of the safety issues associated with conventional isocyanate containing (polyurethane) D4 grades. PVA D4 can be used internally and externally and gives a high strength, water, impact and temperature resistant bond that is usually stronger than the wood itself. Ideal for general woodworking and joinery uses, assembly line work, RF/HF cure systems, wood on wood laminating, furniture assembly and household DIY use. Dries clear. Easy water clean up. Conforms to the international standards EN204 (D4).
Ensure surfaces to be bonded are clean, dry and free from grease. All parts should mate well and be dust and grease free. Uneven parts will give longer setting times and weaker bonds. Moisture content of wood must be within 8-15% w/w. Do not use below 10°c (room or wood temperature). Apply adhesive thinly to both surfaces (150-180g/m2) and assemble immediately. Remove excess adhesive with a damp cloth immediately. May be handled carefully after 10 minutes (initial setup). Clamp or apply weight pressure for 3-4 hours or use industrial press.
HEALTH AND SAFETY
Safe in normal use. However; as a precaution, wash splashes off skin and if product enters eyes, flood immediately with cold water. Do not take internally. Keep out of the reach of children.
MP Supplies - Ironmongery and Fittings North Devon